Avionics and Interfaces for Flight Simulation


Elite HW Interface 3 for X-Plane 10.20 or greater and X-Plane 11

Fully networked - Elite Controls can be on a networked computer.
Supported Elite Hardware includes:

Go to online store

A trial version is available in our downloads section.

  • Elite Yoke
  • Elite Pro Panel SE
  • Elite Pro Panel II
  • Elite Pro Panel III
  • Elite Standalone Throttle Quadrant (Multi or Single Engine and King Air)
  • Elite Rudder Pedals
  • Elite AP2000 Avionics Stack (only when converted to USB. GPS in stack not supported) new!
  • Elite AP3000 Avionics Stack (Apollo GPS in stack not supported)
  • Elite AP4000 Avionics Stack (8.33Khz COM/NAV is supported)new!
  • Elite AP5000 Avionics Stack (AP4000 with Emuteq G530, 8.33Khz COM/NAV is supported)new!
  • Elite iGate TH-100 Avionics
  • Elite COM/NAV Radio (2 modules supported for COM1/NAV1 and COM2/NAV2)
  • Elite COM/NAV Radio 8.33 KHz (2 modules supported for COM1/NAV1 and COM2/NAV2)new!
  • Elite ADF Radio Module
  • Elite DME Radio Module
  • Elite Auto Pilot Module
  • Elite Altitude Pre-Select and Audio Panel Module
  • Elite Transponder Module
  • Elite NAV/CRS/HDG Module
  • Elite GNS430 Module (2 GPS modules supported only for X-Plane GPS)
  • Elite GNS530 Module (2 GPS modules supported only for X-Plane GPS)
  • Elite Compass
  • Elite E500 Module (2 modules supported for Pilot & Copilot)
  • Elite GTN Module (2 modules supported for Reality XP GTN750/650)
  • Elite EFS40 Module (2 modules supported, preconfigured for Carenado aircraft)

IMPORTANT! This software only supports Elite Devices with a USB Interface.
Serial Devices (RS232) are NOT supported, even when used with a serial to USB converter!

This Interface supports both 32bit and 64bit versions of X-Plane 10.20 or greater and X-Plane 11 (64bit only).

The driver is completely configured for all devices listed above. There is no need to map or assign any buttons, dials etc in X-Plane.

GPS devices support up to 2 X-Plane GPS devices.

Reality XP GNS430/530, GTN750/650 and FTS SimAvio GNS430/530:

SimAvio is no longer offering the FTS GNS430/50. We can no longer guarantee that this will remain working correctly. We discovered already bugs with the FTS software in later versions of X-Plane.

Reality XP (Version1) for X-Plane is an old product that has never been ported to X-Plane 64 Bit, it only works in 32 Bit mode. There seems to be no development under way to make this happen. We cannot guarantee this product to continue work with this Interface. It only works with X-Plane 10 32 bit! (X-Plane 11 is 64 bit only!)

Reality XP GNS 430/530 V2 is fully supported in X-Plane 10 (32bit & 64bit) and X-Plane 11 (64bit). This is the Reality XP Version that runs inside X-Plane, not as a separate application. The Reality XP GNS can be configured as a separate window though.

Reality XP GTN 750/650 is fully supported in X-Plane 10 (32bit & 64bit) and X-Plane 11 (64bit). You need to purchase one or two Elite GTN Modules.

Pilot Edge Compatible when using Pro Panel.

Download the User Manual for more Information.